Laboratory Press

Description
Hydraulic press for testing on ceramics. Essentially consisting by a support base steel epoxy painted, two column steel zinc, two cylinders and an hydraulic power-pack with oil tank. The maximum pressure from the top cylinder can be adjusted by the operative (see models below). Once manually charged in the mould the powder is being pressed by the upper cylinder up to the maximum pressure request. As soon as the cycle is over the sample can be taken out with the lower cylinder. With the automatic version (code GT2074 and GT2118) is possible to programming up to three pressing cycle and three filling. The filling of the mould is made manually by the operator. The press come without mould, that should be ordered on request The moulds are avaible on request
Technical Specifications

Press Touch:

Manual pressure gauge

Speed adjuster to the extracting

Built-in pressure gauge on the panel or with touch screen

Supply: 400 V - 50 Hz three phases (other voltage on request)

Programming the worring cycle through touch screen

Possible to set up to 10 Recipes

Click here for more info

Clique aqui para mais informações